Tips for fixing Leaky Faucets | HomeServe USA

Thứ Hai, ngày 11/07/2022 - 22:44

194

Below is an article on the topic Tips for fixing Leaky Faucets | HomeServe USA compiled by the editors of Gootoplist.com. Gootoplist - a general information page about useful tips for life

We have Canadian website.

No, stay in the USA

Call Today 877-340-0919

Watch your inbox for our simple home maintenance tips.

There’s nothing worse than the drip...drip...drip of a leaky faucet. Not only can it keep me awake at night, but it can add big bucks onto my water bill. That’s why fixing a leaky faucet ASAP is always a good idea. With a few tools and the right advice, it’s a simple DIY project.

Keep in mind that the repair process will differ depending on the type of spout and sink, but you can follow this basic advice for how to stop a leaky faucet.

It’s best to always be vigilant of dripping faucets, as a single leaky fixture can waste 20 gallons of water a day! Give your sink a once-over to try to identify the source of the leak. If water is pooling around the stem of the faucet, you most likely need to replace the O-ring or tighten the packing nut.

If the leak is coming from the spout, there’s most likely a problem with the faucet handle. At this point, it’s helpful to have some knowledge about which type of faucet is in your home. The Spruce explained that a cartridge faucet is most common in modern homes, and you’ll typically need to replace the cartridge.

A compression faucet, on the other hand, is more typical in older homes. The rubber seals can wear out over time, so replacing them can usually remedy a dripping faucet.

Many of the tools you’ll need to stop a leaky faucet can already be found in your tool box. SFGate Home Guides recommended gathering these materials before your get to work:

DIY faucet repair is incredibly inexpensive. All you need to pay for is parts. A pack of washers costs less than $3 at Home Depot, so changing them yourself is cost-effective if you know how.

You might also want to have an allen wrench or adjustable wrench on hand for loosening valves and nuts. Slip-joint pliers can serve the same purpose and help you gain a better grip on small faucet parts that need to be tightened during reassembly.

Whether it's a persistently leaky shower faucet or dripping sink spout, follow these steps for how to stop a leaky faucet:

Always turn off the water supply before doing repair work. Look for the shutoff valves under the sink. Turn them clockwise until they're tightly closed. Avoid using too much force, as overtightening can cause damage. If the valves aren't under the sink, you'll need to close the main water valves. These devices are usually located in the basement or near the washer, dryer and hot water heater. Once you've shut off the valves, turn the faucet on to release pressure and drain remaining water in the pipes.

You're going to be working with small screws as you take apart the faucet, and you don't want them to end up lost down the drain pipes. Avoid catastrophe by concealing holes with covers or plugs. You can also push a rag down the pipe.

Depending on your type of sink, you may need to remove the faucet body to reach the problem, but ideally all you’ll have to do is remove the handle. For ceramic disc faucets, Lowes explained this begins with removing the set screw, and taking out the retaining nut before replacing the cylinder.

For a cartridge faucet, the steps are pretty similar, but you will also have to detach the retaining clip or nut to replace the cartridge.

Pay attention to the order and orientation of the parts as you remove them. This diligence makes for much easier reassembly. To help you remember, set the parts aside in the order you disassembled them or take photos as you work.

Seals, rubber washers and O-rings are often the culprits when a faucet starts to leak. Inspect them for obvious wear and tear, such as a flattened washer or grooves worn into the parts. If they look rough, replace them. Take the old parts to the store with you to ensure you're buying the right replacements. Alternatively, replace with a washerless faucet to help avoid the issue in the future.

Take advantage of this time to clean the parts before you reassemble them. Once parts are removed, clean all seals and interior cylinders. Check the valve seat for mineral deposits that could cause the washer to not be flush and result in leaks. Use a cloth to clean the surfaces, and loosen these deposits by soaking them in white vinegar.

This is where those pictures you took earlier come in handy. With your tools in hand, reverse the dismantling process to assemble the faucet. Make sure to never push down on the faucet or force parts to work.

Once you've finished the repair, you'll need to turn the water back on. Expert advice from Lowes: Make sure the faucet is in the “on” position, and turn the water back on slowly. If the faucet is in the “off” position or there's too much pressure applied too quickly, it may cause more serious damage, such as cracking the ceramic disc. Let the water run until it flows normally.

If an old faucet is giving you issues, it's usually a good idea to go ahead and replace it altogether with an updated cartridge model. If you can’t determine the cause of the leak or are unable to solve it with a quick fix, it’s best to call in a plumber who has the tools and knowledge to effectively identify and resolve the problem.

Being prepared before home maintenance issues arise is always a good strategy. See how plans from HomeServe can help with the costs of covered repairs.

Call today for a local plumber.

Corporate office: 601 Merritt 7, Norwalk, CT 06851

HOMESERVE®, the HOMESERVE Design® and HOMESERVE USA® are trademarks of HomeServe PLC. All third party entity names and logos are trademarks or registered trademarks of their respective holders.

Get the latest news, tips and promotional messages, including special offers.

HomeServe is an independent company seperate from your local utility or community.

Regional office:150 King Street West Suite 200, Toronto, ON M5H 1J9

All rights reserved HOMESERVE®, the HOMESERVE Design® and HOMESERVE Canada are trademarks of HomeServe PLC. All third party entity names and logos are trademarks or registered trademarks of their respective holders.

HomeServe uses cookies to recognize repeat visits and to enhance your experience on our site. By continuing to use this website you agree with our use of cookies. Privacy Policy

Unfortunately we don’t currently offer coverage in at this time. Please check back soon.

Above is the article Tips for fixing Leaky Faucets | HomeServe USA shared by Gootoplist team. Next, I also write an article related to this article to synthesize the knowledge about how to fix a leaky faucet Hope to bring you useful information, thank you for your interest and follow. track!